TORXUN AUTOPED M10S.0028, Руководство по установке, Страница: 25 / 82

Autoped Installation Manual rev 2.0 (100722)
25
STEP 5 Mark the mounting holes of the Chassis on the
Header
STEP 6 Take down the Chassis with the assemblies
STEP 7 Drill pilot holes for Chassis mounting on the Header
STEP 8 Mount
12
the Chassis with assemblies on the Header
STEP 9 Mount the Track Guide on the Door/Gate Frame
•
Insert the Slide Piece in the Track Guide
•
Place the Track Guide on the Door/Gate Frame
•
Move the end of the Track Guide about 4
” from the Slide
Piece, (see illustration above)
12
Type, size, and material of fasteners by installer
STEP 10 Perform the following check:
a. Manually open and close the Door/Gate to check
for a smooth and unobstructed swing of the
Door/Gate panel.
b. Check that the Slider piece glides smoothly inside
the Track Guide.
STEP 11 Replace the left and right endcaps of the Track
Guide.
STEP
12 Proceed to Section V to install the Rocker Switch (or
Key Switch).
NOTE:
All the preceding installation steps also apply to a Right-hand
mounted operator . Note
that the measure of 4” in
Step 9 will
be on the opposite side of the illustration for a Right-hand
install.