Toro TimeCutter SW 4200, Руководство оператора

Страница: 47 / 60

G009659
1
2
3
2
3
Figure 61
Mower decks with 3 Blades
1. Blades front to rear 3. Measure from the tip of the
blade to the flat surface
here
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat surface
(
Figure 60 and Figure 61 ).
Note:
If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (
Figure 62 ).
G014634
1
2
3
Figure 62
1. Adjusting rod 3. Lock nut
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
9. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (
Figure 60 and Figure 61 ).
10. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again, refer to
Side-to-Side Leveling (page 45) .
Removing the Mower
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Loosen the bottom two bolts holding the mower-deck
curtain to the mower deck. Refer to
Releasing the
Mower-Deck Curtain (page 33) .
5. Remove the hairpin-cotter pin from the front support
rod, and remove the rod from the deck bracket (
Figure
63 ).
G014635
1
2
3
Figure 63
1. Front support rod 3. Deck bracket
2. Locking nut
6. Carefully lower the front of the mower deck to the
ground.
7. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (
Figure 64 ).
47