Toro ProCore 1298, Руководство оператора

Страница: 27 / 32

g007317
Figure 37
1. Lower belt shield 2. Dirt shield
4. To release the idler spring tension, loosen the locknut
securing the spring retainer (
Figure 38 ) and rotate the
spring retainer.
g007319
Figure 38
1. Spring retainer locknut
CAUTION
Springs are under tension, use caution when
adjusting or removing.
5. Loosen and remove the 2 locknuts and washers
securing the rotalink damper for the #1 stomper arm
(
Figure 39 ).
g007320
Figure 39
1. Drive belt 4. Washer
2. Rotalink damper 5. #1 Stomper arm
3. Nut
6. Lower the rotalink damper from the coring head frame.
7. Route the drive belt down through the coring head
frame and around the lower end of the #1 stomper
arm (
Figure 39 ).
Installing the Belt
1. Route the new drive belt around the lower end of the
#1 stomper arm and up through coring head frame.
2. Position the drive belt onto the crank pulley, under the
idler assembly and over the drive pulley.
3. Raise the rotalink damper for the #1 stomper arm to
coring head frame. Ensure that the damper spacers are
installed in the same position as in removal.
4. Secure the rotalink damper to the coring head with the
2 washers and locknuts previously removed.
5. Install and adjust the belt idler pulley and adjust it to
the appropriate tension.
6. Install the dirt shield and the lower belt shield. Adjust
the lower shield to ensure clearance with the belt.
7. Install the pulley and the coring head covers.
27