Toro ProCore 1298, Руководство оператора

Страница: 23 / 32

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the gearbox lubrication.
• Check the torque of the coring head fasteners.
Before each use or daily
• Check the belt tension.
• Check the belt tension.
Every 50 hours
• Grease the bearings and bushings.
• Inspect the bearings.
Every 100 hours
• Check the gearbox lubrication.
Every 250 hours
• Change the gearbox lubrication.
• Check the torque of the coring head fasteners.
Every 500 hours
• Inspect and replace the bearings as needed.
Before storage
• Perform all 50-hour maintenance procedures.
• Paint areas that are scratched, chipped, or rusted.
• Remove and clean the tines.
• Remove all debris.
Yearly
• Inspect the belts.
Jacking the Machine
CAUTION
If the machine is not properly supported by blocks
or jack stands, the machine may move or fall, which
may result in personal injury.
When changing attachments or performing
other service, use correct blocks, hoists or jacks.
Ensure that the machine is parked on a solid, level
surface such as a concrete floor. Prior to raising
the machine, remove any attachments that may
interfere with the safe and proper raising of the
machine. Always chock or block the tow vehicle
wheels. Use jack stands or solid wood blocks to
support the raised machine.
Note:
If available, a hoist can be used to lift the rear of the
ProCore Aerator. Use the eyelets in the coring head bearing
housings as hoist attachment points (
Figure 27 )
g007308
Figure 27
1. Lifting eyelets
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The main working bearings of the aerator are sealed for life
and require no maintenance or lubrication. This drastically
reduces the maintenance required and eliminates the risk of
grease or oil being dropped onto the turf.
There are grease fittings that must be lubricated with an SAE
multi-purpose, high-temperature grease with high-pressure
23