Toro ProCore 1298, Руководство оператора

Страница: 26 / 32

decal110-4667
Figure 33
1. Spring length
2. Stored energy hazard—read the Operator's Manual .
3. Entanglement hazard, belt—stay away from moving parts.
2. Adjust the belt tension as follows:
A. Remove the rear coring head cover ( Figure 34 ).
g007316
Figure 34
1. Rear coring head cover 2. Pulley shield
B. Remove the pulley shield mounting bolts and
remove the shield (
Figure 34 ).
C. Loosen the locknut securing the spring retainer
(
Figure 35 ).
g007315
Figure 35
1. Spring retainer 2. 146 mm (5-3/4 inches)
D. Adjust the spring retainer to attain required
compressed spring length (
Figure 35 ).
E. Tighten the locknut against the spring retainer to
lock the adjustment.
F. Install the pulley shield and the coring head cover.
Replacing the Drive Belt
Note:
The outboard stomper arm does not need to be
removed to replace the drive belt.
Removing the Belt
1. Remove the rear coring head cover ( Figure 36 ).
g007316
Figure 36
1. Rear coring head cover 2. Pulley shield
2. Remove the pulley shield mounting bolts and remove
the shield (
Figure 36 ).
3. Remove the fasteners securing the dirt shield and the
lower belt shield (
Figure 37 ). Remove the dirt shield
and the lower belt shield.
26