Toro ProCore 1298, Руководство оператора

Страница: 14 / 32

8
Installing the Tine Heads and
the Tines
No Parts Required
Procedure
A wide selection of tines and tine heads are available for the
aerator. Choose the tine type, size, and spacings required for
the job. Install the tine head and tines per the Installation
Instructions supplied with each tine kit. Refer to
Figure 21
and Figure 22 for the accessories.
Important:
Never operate the aerator without the tine
heads installed. The arms may move excessively and
damage the aerator frame.
9
Installing the Turf Guards
Parts needed for this procedure:
–
Turf guards (not included)
Procedure
A wide selection of turf guards are available for the aerator.
Use the appropriate turf guards for the selected tine heads.
1. Loosen the nuts securing the turf guard clamps to the
turf guard tool bar (
Figure 17 ).
g007331
Figure 17
1. Turf guard 2. Turf guard clamp
2. Slide the appropriate turf guard under the turf guard
clamp.
3. Adjust the turf guards, left to right, to maintain equal
distance to the tines within each slot.
4. Tighten the nuts securing the turf guard.
5. Mount the remaining turf guards and secure the turf
guard clamps.
Important:
From the rear of the machine, check
that the tines line up with the center of the gaps
in the turf guards.
10
Securing the Hood Latches
(CE only)
Parts needed for this procedure:
1 CE Compliance Kit, Part 110-4693 (not included)
Procedure
Note:
The CE Completion Kit, Part 110-4693 is required
to complete this step.
1. On the ProCore 864 model, install a lock bracket over
the left and right rear lower hood and upper hood
latches with a tap bolt (4 total); refer to
Figure 18 .
g007299
Figure 18
1. Tap bolt 3. Internal lock washer
2. Lock bracket 4. Rear cover
2. On the ProCore 1298 model, install a lock bracket over
all the rear lower hood latches and the outside upper
hood latch on both the right and the left rear covers
with a tap bolt (3 per coring head, 6 total); refer to
Figure 18 ).
14