Toro Multi Pro 5800, Руководство оператора

Страница: 24 / 36

g192380
Figure 67
1. Measured-distance value 2. Entered-distance value
•
A message displays confirming that the
speed calibration is successful (
Figure 68 ).
g192425
Figure 68
•
A message displays indicating that the speed
calibration is failed (
Figure 69 ).
Note:
Press button 5 to exit the Speed
Calibration screen.
Note:
If the calibration value is out of bounds
( Figure 69 ), contact your authorized Toro
service dealer; otherwise, review the error
message and repeat the calibration steps in
Preparing for the Speed Calibration (page
22)
and Performing the Speed Calibration
(page 23) .
g192424
Figure 69
5. Press button 5 to exit the Speed Calibration
screen (
Figure 68 or Figure 69 ).
6. Move the throttle to the S
LOW
position, shut
off the engine, engage the parking brake, and
remove the ignition key.
Test Speed
Use the test speed feature to simulate a ground speed
signal for stationary sprayer operation for the following
tests:
•
Setting the section-bypass valves (manual mode),
refer to the
Operator’s Manual for the machine.
•
Verify the catch test for machines operated in the
application-rate mode.
Note:
If you release the parking brake or move the
machine while using the speed test simulation, the
InfoCenter exits the simulation.
Using the Test Speed
1. Press buttons 1 or 2 on the
CALIBRATION
sub-menu to navigate to the
TEST SPEED
option
( Figure 70 ).
g193668
Figure 70
24