Toro 30488, Руководство оператора

Страница: 17 / 60

4. Move the throttle control to Fast, and move the choke
lever to the On position before starting a cold engine
(
Figure 9 ).
Note:
A warm or hot engine may not require choking.
To start a warm engine, move throttle control midway
between the
Fast and Slow positions.
Figure 9
1. Ignition switch 3. Choke
2. Throttle lever
5. Turn the ignition key to the start position to energize
the starter.
Note:
When the engine starts, release the key.
Note:
Do not engage the starter for more than 5
seconds at a time. If the engine fails to start, allow
for a 15-second cool-down period between attempts.
Failure to follow these instructions can burn out the
starter motor.
6. When engine starts, move the throttle control between
the Fast and Slow position, and move the choke lever
to the Off position.
7. Allow the engine to warm up and then move the
throttle control to the Fast position.
Stopping the Engine
1. Move the motion-control levers to neutral and move
the right side motion-control lever into the neutral-lock
position.
2. Move the throttle lever to Slow ( Figure 9 ).
3. If the engine has been working hard or is hot, let the
engine idle for 30 to 60 seconds before turning the
engine off.
4. To stop the engine, turn the ignition key to off.
Important:
Ensure that the fuel-shutoff valve is
closed before transporting or storing the machine,
as fuel leakage may occur. Before storing the
machine, pull wire off spark plug(s) to prevent
possibility of accidental starting.
Operating the Mower-Blade
Control (PTO)
The blade-control switch (PTO) is used in conjunction with
the right side motion-control lever to engage and disengage
the mower blades.
Engaging the Mower Blades (PTO)
1. To engage the mower blades, move the right side
motion-control lever to the center, unlocked position
(
Figure 10 ).
2. Pull the blade-control switch (PTO) up and release it
while holding down the right side motion-control lever
in the center, unlocked position.
Figure 10
1. Blade-control switch
(PTO) 3. Right motion-control lever
in neutral-lock position
2. Right side motion-control
lever pushed down into the
center, unlocked position 4. Left motion-control lever
Disengaging the Mower Blades (PTO)
The following are 2 options for disengaging the mower blades.
•
Push the blade-control switch (PTO) down to the Off
position.
•
Move the motion-control levers to neutral, and move
the right side motion-control lever into the neutral-lock
position.
17