Toro 30488, Руководство оператора

Страница: 41 / 60

Controls System
Maintenance
Adjusting the Motion-Control
Handle
Adjusting the Right Motion-Control
Lever
If the motion-control levers do not align horizontally, adjust
the right motion-control lever.
Note:
Adjust the horizontal alignment before the
front-to-back alignment.
1. Disengage the PTO, move the right motion-control
lever to the neutral position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push the right motion-control lever down out of the
Neutral-Lock position (
Figure 53 ).
4. Check if it aligns horizontally with the left
motion-control lever (
Figure 53 ).
Figure 53
1. Left motion-control lever 3. Check the horizontal
alignment here
2. Right motion-control
lever in the Neutral-Lock
position 4. Right motion-control lever
5. To adjust the right motion-control lever horizontally,
the cam needs to be adjusted.
6. Remove the cover under the control panel.
7. Loosen the nut and bolt holding the cam ( Figure 54 ).
8. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut and bolt for
the cam.
Figure 54
1. Cam 4. Turnbuckle
2. Nut and bolt 5. Switch screws
3. Wing nut
9. After the cam is adjusted, the lever switch needs to be
checked.
10. Check the gap between the control lever and the switch
as shown in
Figure 55 . The gap needs to be between
1.6 to 2.4 mm (1/16 to 3/32 inch).
11. If needed, loosen the screws holding the switch and
adjust the switch.
12. Tighten the screws and install the cover under the
control panel.
41