Toro 30488, Руководство оператора

Страница: 21 / 60

Figure 15
1. Carrier frame 4. Spacers
2. Hairpin cotter 5. Front of the height-of-cut
post
3. Back of the height-of-cut
post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be 10
mm (3/8 inch) minimum clearance above the ground.
Note:
If the anti-scalp rollers are adjusted too low, it can
cause excess wear of the rollers.
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 10 mm (3/8
inch) clearance above the ground (
Figure 16 , Figure
17 , Figure 18 ).
2. If adjustment is needed, remove the bolt, washers, and
nut (
Figure 16 , Figure 17 , Figure 18 ).
3. Select a hole position, so the anti-scalp rollers are a
minimum of 10 mm (3/8 inch) off the ground (
Figure
16 , Figure 17 , Figure 18 ).
4. Install the bolt and nut ( Figure 16 , Figure 17 , Figure
18 ).
Figure 16
40 inch, 48 inch, and 52 inch Mower Decks
1. Mower deck 4. Anti-scalp rollers
2. Bolt 5. Nut
3. Spacer
Figure 17
40 inch, 48 inch, and 52 inch Mower Decks
1. Mower deck 4. Bushing
2. Bolt 5. Anti-scalp rollers
3. Spacer 6. Nut
21