Toro 30488, Руководство оператора

Страница: 18 / 60

Using the Safety-Interlock
System
CAUTION
If safety-interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety-Interlock
System
The safety-interlock system is designed to prevent the mower
blades from rotating unless:
•
The right side motion-control lever is moved to the
center, unlocked position.
•
The blade-control switch (PTO) is pulled to the On
position.
The safety-interlock system is designed to stop the mower
blades if you move or release the right side motion-control
lever into the neutral-lock position.
The hour meter has symbols to notify the user when the
interlock component is in the correct position. When the
component is in the correct position, a triangle will light
up in the corresponding square.
Figure 11
1. Triangles light up when the interlock components are in the
correct position
Testing the Safety-Interlock System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the machine
each time.
Note:
If the safety system does not operate as described
below, have an Authorized Service Dealer repair the safety
system immediately.
1. Start the engine; refer to Starting the Engine (page 16) .
2. Set the parking brake.
3. Move the right side motion-control lever to the center,
unlocked position.
Note:
The blades should not rotate.
4. Move the motion-control levers forward.
Note:
The engine should stop.
5. Start the engine and release the parking brake.
6. Move the right side motion-control lever to the center,
unlocked position.
7. Continue holding the right side motion-control lever
in the center, unlocked position, and pull up on the
blade-control switch (PTO) and release.
Note:
The clutch should engage and the mower
blades should begin to rotate.
8. Move or release the right side motion-control lever into
the neutral-lock position.
Note:
The blades should stop rotating.
9. Move the right side motion-control lever to the center,
unlocked position.
10. Continue holding the right side motion-control lever
in the center, unlocked position, and pull up on the
blade-control switch (PTO) and release.
Note:
The clutch should engage and the mower
blades should begin to rotate.
11. Push the blade-control switch (PTO) down to the Off
position.
Note:
The blades should stop rotating.
12. With the engine running, pull up the blade-control
switch (PTO), and release it without holding right side
motion-control lever to the center, unlocked position.
Note:
The blades should not rotate.
Driving Forward or Backward
The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the Fast position for best performance. Always operate in the
full-throttle position when mowing.
CAUTION
The machine can spin very rapidly, causing the
operator to lose control of machine, which could
cause personal injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
18