Toro 30488, Руководство оператора

Страница: 22 / 60

Figure 18
36 inch Mower Deck
1. Mower deck 4. Anti-scalp rollers
2. Bolt 5. Nut
3. Spacer
5. In certain mowing conditions and terrain, a mismatch
of cutting height may be seen. Adjusting the outside
anti-scalp rollers to the minimum setting of 10 mm
(3/8 inch) will help prevent the mower deck cutting
too low on the outside and minimize the mismatch.
Adjusting the Flow Baffle
The mower discharge flow can be adjusted for different types
of mowing conditions. Position the cam lock and baffle to
give the best quality of cut.
1. Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. To adjust the baffle, loosen the nut ( Figure 19 ).
4. Adjust the baffle and nut in the slot to the desired
discharge flow, and tighten the nut.
g012676
1 2
Figure 19
1. Slot 2. Nut
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments will vary by grass type, moisture content, and
the height of the grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position (see Figure 20 ). The suggested
use for this position is a follows.
•
Use for short, light grass mowing conditions.
•
Use in dry conditions.
•
For smaller grass clippings.
•
Propels grass clippings farther away from the mower.
G012677
Figure 20
Position B
Use this position when bagging ( Figure 21 ).
G012678
Figure 21
22