Toro 30488, Руководство оператора

Страница: 16 / 60

of varnish deposits in the fuel system, use fuel stabilizer
at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around the fuel tank cap and remove the cap.
Add unleaded regular gasoline to the fuel tank, until the
level is 6 to 13 mm (1/4 to 1/2 inch) below the bottom
of the filler neck. This space in the tank allows the
gasoline to expand. Do not fill the fuel tank completely
full.
3. Install the fuel tank cap securely. Wipe up any gasoline
that may have spilled.
Checking the Engine-Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to
Checking the
Engine-Oil Level (page 27) .
Note:
Determine the left and right sides of the machine
from the normal operating position.
Putting Safety First
Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you or
any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet and
head is recommended.
CAUTION
This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
The use of protective equipment for eyes, ears, feet, and head
is recommended.
G009027
1 2
Figure 7
1. Wear safety glasses 2. Wear hearing protection
Operating the Parking Brake
Always set the parking brake when you stop the machine or
leave it unattended. Before each use, check the parking brake
for proper operation.
If the parking brake does not hold securely, adjust it; refer to
Setting the Parking Brake (page 16) .
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Setting the Parking Brake
Pull the parking-brake lever rearward ( Figure 8 ).
Figure 8
1. Parking-brake lever (in the
released position) 2. Parking-brake lever (in the
engaged position)
Releasing the Parking Brake
Push the parking-brake lever forward.
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Set the parking brake.
16