Toro 07161, Руководство по установке, Страница: 28 / 32

14
Assembling the Latch Pin
Parts needed for this procedure:
2 Latch pin
4 Thrust washer
2 Pin guard
2 Jam nut
Procedure
1. Align the latch pin and the pin guard with the
opening at the mount bracket as shown in
Figure
63 .
2. Insert the latch pin (without the washers at first)
into the pin guard (
Figure 63 ).
Note:
If the latch pin is not centered in the door
latch, add 1 or 2 of the thrust washers. Use the
thrust washers to align the latch pin to the door
handle latch.
g213550
Figure 63
1. Jam nut 4. Latch pin
2. Mount bracket 5. Pin guard
3. Thrust washer
3. Align the latch pin and the jam nut onto the back
side of the opening at the mount bracket (
Figure
63 ).
4. Tighten the jam nut onto the latch pin by hand
(
Figure 63 ).
15
Installing the Canopy
Parts needed for this procedure:
1
Sunshade
2 Clip
4 Sealing washer
4 Hex-flange bolt (1/4 x 1 inch)
2 Friction washer
4 Plastic washer
2 Flange bushing
Procedure
1. Install the sunshade to the front plates using 2
clips, 2 sealing washers, and 2 hex-flange bolts
(1/4 x 1 inch) as shown in
Figure 64 .
Important:
Apply thread-locking compound
to the hex-flange bolts before installing.
g035017
Figure 64
1. Hex-flange bolt (1/4 x 1
inch) 4. Clip
2. Sealing washer 5. Front plate
3. Sunshade
2. Install the sunshade to the rear crosslink using
2 hex-flange bolts (1/4 x 1 inch), 2 sealing
washers, 2 friction washers, 4 plastic washers,
and 2 flange bushings (
Figure 65 ).
28