Toro 07161, Руководство по установке, Страница: 21 / 32

Removing the Bumper from the
Machine
1. While supporting the bumper, remove the 8
flange-head bolts that secure the bumper to the
bumper mounts and headlight brackets (
Figure
42 )
g237475
Figure 42
1. Bumper 3. Flange-head bolt
2. Bumper and headlight
mount
2. Remove the bumper from the machine.
10
Installing the Headlight
Guards
Parts needed for this procedure:
2 Headlight guard
4 Flange bolt (5/16 x 5/8 inch)
Installing the Headlight Guards
1. Remove the 2-socket connector of the machine
wire harness from the 2–pin connector at the
back of the head light (
Figure 43 ).
Note:
Retain the clips for assembly.
g237538
Figure 43
1. Headlight-adjusting nut 3. Clip
2. Headlight bracket 4. 2-socket connector
(machine wire harness)
2. Remove the 3 clips from the 3 headlight-adjusting
nuts, and remove the headlight from the
headlight bracket (
Figure 43 ).
3. Inspect the headlight mount brackets for the
headlight guard mounting holes.
If the headlight mount brackets do not have
mounting holes, use the measurements in
Figure 44 to drill 2 holes—11 mm (7/16 inch) in
each of the headlight mount brackets.
21