7
Installing the Seat
Assembly
No Parts Required
Procedure
Slide the seat assembly onto the pins and lower the
seat assembly (
).
g190186
Figure 38
1.
Pins
8
Installing the Doors
Parts needed for this procedure:
1
Right door assembly
1
Left door assembly
2
Door tether
2
Right door hinge
2
Left door hinge
4
Carriage bolt (5/16 x 2-3/4 inches)
4
Shoulder bolt (5/16 x 1/2 inch)
4
Spacer
8
Flange nut (5/16 inch)
Procedure
Refer to
as you perform the following steps.
1.
Use 4 carriage bolts (5/16 x 2-3/4 inches) and
4 flange nuts (5/16 inch) to secure the left and
right door hinges to the roll bar.
Note:
This hardware also secures the right and
left sides of the rear screen to the roll bar.
2.
Place a spacer onto each door hinge.
3.
Apply a light coating of grease onto each door
hinge.
4.
Install each door assembly by sliding the doors
onto the door hinges.
Note:
Ensure that each door swings freely.
Adjust the door latch pin so that it is centered in
the door latch handle
5.
Use 4 shoulder bolts (5/16 x 1/2 inch) and 4
flange nuts (5/16 inch) to secure the door tethers
to the door assemblies and the crosslink tubes.
18