Toro 07161, Руководство по установке, Страница: 23 / 32

11
Installing the Ball-Picker
Mount
Parts needed for this procedure:
1 Ball-picker mount
1 Bottom bracket
14 Flange bolt (3/8 x 1 inch)
14 Flange locknut (3/8 inch)
Drilling the Center-Channel Plate
1. Assemble the ball-picker mount onto the bumper
support as shown in
Figure 48 .
g237670
Figure 48
1. Ball-picker mount 2. Bumper support
2. Loosely assemble the bottom bracket onto the
ball-picker mount (
Figure 49 ) with 4 flange bolts
(3/8 x 1 inch) and 4 flange locknuts (3/8 inch).
g237671
Figure 49
1. Bottom bracket 3. Ball-picker mount
2. Flange locknut (3/8 inch) 4. Flange bolt (3/8 x 1 inch)
3. Align the rear-most edge of the bottom bracket
with the edge of the access opening in the
center-channel plate (
Figure 50 ).
g237673
Figure 50
1. Hole (Bottom bracket) 2. Center-channel plate
4. Mark the 4 hole locations of the bottom bracket
onto the center-channel plate as shown in
Figure
50 .
5. Remove the 4 flange bolts (3/8 x 1 inch), 4
flange locknuts (3/8 inch), and bottom bracket
from the ball-picker mount (
Figure 49 ).
23