Topcon Luminance Colorimeter BM-5AC, Инструкция по эксплуатации

Страница: 31 / 103

2.Measurement Operation
29
Next, place the BM-5AC to be corrected in the location where the reference instrument is placed,
and measure the same light source.
The correction factor of the BM-5AC to be corrected is calculated based on the data of the
reference instrument and the data of the BM-5AC to be corrected.
The following describes the procedure for performing correction between instruments using the
Direct Correction function.
1
Set the data output method and transmission mode for the reference instrument
beforehand referring to the table below. Then, connect the reference instrument to the BM-
5AC to be corrected using a specified cable. Also, set the RS-232C parameter settings of
the BM-5AC to be corrected to the same settings as those of the reference instrument.
Reference
Instrument
RS-232C Cable Data Output
Method
Transmission
Mode
SR-3A Straight CS900 Program -------
SR-UL1 Straight CS900 Program RS-232C
SC-777 Interlink CM-700 Type RS-232C
BM-7A Interlink FACTOR B RS-232C
BM-5AC Interlink FACTOR B RS-232C
2
Enter the function mode on the BM-5AC to be corrected, and display the [*Factor A / B*]
screen.
Entering the function mode
☞
"3.1.1 Entering/Returning from the Function Mode"
Display method
☞
"3.1.2 Displaying Data/Setting Items"
3
Press the [CHANGE] switch.
4
Press the [ROTATION] switch, select "Factor B", and press the [ENTER] button.
5
Press the [ENTER] button again. The [*DIRECT-CONN FACTOR*] screen is displayed.
6
Press the [CHANGE] switch.
BM-5AC
Light source
* F A C T O R A / B *
F A C T O R A
* D I R E C T - C O N N F A C T O R *
M E A S U R E R E F E R E N C E
M E A S U R E F A C T O R
A L L F A C T O R C L E A R