Topcon ISOBUS Artemis, Руководство по эксплуатации

Страница: 4 / 28

ISOBUS ARTEMIS - SEED DRILL CONTROLLER
2
Most incidents arising during operation, maintenance and repair are caused by a failure to observe basic safety rules or precautions. Always be alert
to potential hazards and hazardous situations. Always follow the instructions that accompany a Warning or Caution. The information these provide
aims to minimize risk of injury and/or damage to property. In particular follow instructions presented as Safety Messages.
Safety Messages and Warnings
The safety symbol is used with the relevant word : DANGER, WARNING or CAUTION. Messages marked in this way recommend safety precautions
and practices. LEARN and apply them.
DANGER : Indicates an imminently hazardous situation that, if not avoided, could result in DEATH OR VERY SERIOUS INJURY.
WARNING : Indicates a potentially hazardous situation that, if not avoided, could result in DEATH OR SERIOUS INJURY.
CAUTION : Indicates a potentially hazardous situation that, if not avoided, could result in MINOR INJURY.
Operator Safety
Good safety practices not only protect you, but also the people around you. Study this manual as part of your safety program. This safety information
only relates to Topcon equipment and does not replace other usual safe work practices.
▪
WARNING: Never operate the machine with any panels or safety guards removed. Any illustrations or photos in this manual that show
panels or guards removed are solely for demonstration purposes. If the removal of panels and guards is necessary for calibration or
maintenance, they MUST be replaced before operation.
▪
Always check that any suspended vehicle attachments or load arm(s) are lowered to the ground before beginning repair or
maintenance work on the machine.
▪
Machine and implement parts can become hot during operation and may be under pressure. Refer to the machine/implement
manual(s).
▪
Wear appropriate protective clothing for the task being undertaken.
▪
Check the Machine is correctly setup/configured and ready for the intended use.
▪
Be aware of safety instructions for/on the Machine including hazards such as crush zones.
▪
Prevent the Machine from being accidentally started if working on it e.g. remove the ignition key, place a warning notice in the cab etc.
▪
Check that the area of Machine operation is clear of people, animals, and obstacles and identify any other possible hazards.
▪
Keep other persons required to be in the vicinity of the Machine fully aware of Your immediate intentions.
If a Topcon Agriculture mobile application is used to augment Your ability to perform tasks that are traditionally performed on the Console directly,
then in addition to observing the above warnings and all other pre-determined site safety requirements that apply when operating a Machine from
the Console, You must also observe the following additional requirements when operating the Machine via the Application:
▪
WARNING: The Application must only be operated by You, the single Console operator wholly responsible for the operation of the
Machine.
▪
The Application must only be used when the Machine is not on public roads.
▪
The Device must be affixed to a rigid mount when used inside the cab while the Machine is moving to avoid a temporary loss of control
if the Device is dropped or misplaced.
▪
The Application must only be used outside of the Machine cab when the Machine is stationary.
▪
When operating the Application outside of the cab of the Machine You must remain within a reasonable distance such that You can
return to the cab-mounted Console in a timely manner to resume control of the Machine under any of the following circumstances:
▪
Battery failure on the Device
▪
Wifi signal is lost or signal strength is too weak for proper operation
▪
The Device is redirected to another application (e.g. a phone call is received)
▪
The Device becomes incapacitated (e.g. device is dropped and damaged)
▪
Any other event that causes the Device to no longer be fit for control of the Application and/or Machine.
▪
Stand well clear of any moving parts of the Machine (e.g. hydraulic folding booms, spreader spinners, etc.) and areas of product
application (e.g. Spray Nozzles, NH3 appliers, etc.).
▪
The Device and Machine must be locked when not in use.