Topcon ISOBUS Artemis, Руководство по эксплуатации

Страница: 12 / 28

ISOBUS ARTEMIS - SEED DRILL CONTROLLER
10
3.5 Setting the Application Rate
3.5.1 Seed and fertiliser
UK859-010.PNG
N OTE: The main screen pag e will not display or otherwise remind you of an off-target rate set for a channel, unless that channel
remains selected.
NOTE: The fan on/off control operates independently of the metering motor on/off control.
Applicator
in Spinner configuration
Set / manually override the target rate as for other seed / fertiliser channels (3.5.1)
The spinner speed may be set between 0 -100% (PWM). It is a
matter of trial and error to establish the % setting to achieve the
desired spread width.
Press , enter the required % speed then touch “ OK ”.
The drilling rate is metric units only i.e. kgs/ha .
To set the Target r ate for a selected channel :
First select the channel that you want to set the rate f or .
Press , enter the required rate the n touch “ OK ”.
The maximum speed to maintain the application is calculated
and displayed. Press “OK” to return to the main screen.
The system will then automatically maintain this rate
rrespective of forward speed (within limits).
To manually override the Rat e for a select ed channel :
For the selected channel, at any time you can adjust the
rate up or down in 5% increments to suit field conditions ,
up to a maximum ±50% fro m the target rate.
Press to return to the target rate.
3. 5 .2 Pellet/ S mall seed Applicator
Where fitted, a pellet / small seed applicator will be factory -
configured for either of two mo des of operation – ‘ Fan ’ or
‘ Spinner ’ . The mode is indicated by the or key.
Applicator in Fan configuration
Set / manually override the target rate as for other seed / fertiliser
channels (3. 5 .1)
The fan is normally le ft on but should you need to , press to
s witch it off ( indicated by ) as required.
UK 859 - 400 .PNG