Top Air TA1200, Руководство оператора и список запасных частей

Страница: 37 / 102

3-9
Maintenance
WING ADJUSTMENTS
Several areas of adjustment have been
designed into the booms to maintain
proper wing folding operation throughout
the life of the booms.
Inner Wing Adjustments
(80’/90’ Booms Only)
Due to the interrelated nature of the
adjustments of the inner wings,
these
steps should be verified or
adjusted in the sequence presented.
Inner Wing Alignment
(80’/90’ Booms Only)
1. Hitch sprayer to tractor and fully
extend boom.
2. Verify that steel bumper on inner wing
is in firm contact with intermediate
wing. If wing motion is insufficient to
allow steel bumper to contact
intermediate wing, perform the
following
Preliminary gull wing link
adjustment:
a. Remove the two 3/8"x1" bolts on
the gull wing link at its flange
joint.
b. Loosen tie rod jam nut on gull
wing link.
401909
c. Rotate gull wing link tube until
bumper on inner wing contacts
intermediate wing. Continue to
rotate tube as necessary to align
holes at flange joint.
d. Install bolts and tighten jam nut.
3. Vary amount of washers under
bumper until desired degree of
straightness between wing sections is
achieved.
•Revised 011405
Wing Latch Pin
(80’/90’ Booms Only)
1. Hitch sprayer to tractor and fully
extend boom.
2. Verify that the steel bumper on the
inner wing is in firm contact with
intermediate wing. If necessary for
bumper to contact intermediate wing,
perform preliminary gull wing link
adjustment procedure previously
described.
3. The latch pin is correctly adjusted
when latch fully engages pin, but
does not allow pin to bottom-out in
latch slot. Remove or add shims
behind pin weldment as necessary to
achieve correct adjustment.
401908