Top Air TA1200, Руководство оператора и список запасных частей

Страница: 40 / 102

3-12
Maintenance
Main Wing Fold Cylinder
(110’/120’/132’ booms Only)
•Revised 011405
Intermediate Wing Adjustment
(110’/120’/132’ booms Only)
For proper boom performance, the
intermediate wing latch must fit tightly to
the latch pin.
1. Hitch sprayer to tractor and fully
extend boom.
2. Loosen four bolts on side of latch
plate.
3. Using stop bolt, adjust latch plate until
all clearance to latch pin is removed.
4. Tighten bolts loosened in Step 2.
Tighten bolt and jam nut.
5. Fully fold and unfold main wings.
Readjust latch plate if necessary for
correct operation.
Fig. 2
Latch Plate
Latch Pin
Stop Bolt
Jam Nut
Loosen to Adjust
Outer Wing Level Adjustment
(All Boom Sizes)
The outer wing contacts a rubber bumper
when fully extended. Periodically inspect
bumper for deterioration and replace if
necessary.
401911
Use the following procedure to adjust the
alignment of the boom with the wing rests.
1 . Begin with the wings in the unfolded
position.
2. Retract outer wings and extend tilt
cylinders to fully tilt wings upward.
3. Fully raise the main lift.
4. Fully retract main wings.
5. Carefully lower main wings by
retracting tilt cylinders. (It may take
several seconds before wings begin
lowering.) Stop lowering wings just
before they enter wing rests.
6. Inspect position of wings, relative to
wing rests. If wings do not line up
reasonably well with wing rests, adjust
main wing fold cylinder stop bolts as
needed until wings align correctly with
wing rests.
Stop Bolt
Fig. 3