Top Air TA1200, Руководство оператора и список запасных частей

Страница: 39 / 102

3-11
Maintenance
•Revised 011405
401909
Lastly, the adjustment of the gull wing link
should be verified. The correct
adjustment of this link allows the wing
latch to engage the latch pin when the
wing is fully extended, while permitting the
intermediate wing to fully fold against the
inner wing when fully retracted.
1 . Fully extend main wings. If either wing
latch does not engage its latch pin,
lengthen the gull wing link on that wing
1/2 turn, using the preliminary gull wing
link adjustment procedure previously
described.
2. Fully raise main lift and retract tilt
cylinders to fully tilt wings upward.
3. Fully retract, then extend main wings.
4. If either wing latch still does not
engage its latch pin, lengthen the gull
wing link on that wing an additional 1/2
turn and repeat steps 2 and 3 until
both latches engage their latch pins
when wings are extended.
Gull Wing Link
(80’/90’ booms only)
5. Fully retract main wings, then lower
onto wing rests. If either intermediate
wing does not fold completely, extend
main wings and shorten the gull wing
link on that side a half turn at a time
until wing latches will no longer
engage when the wings are extended.
When this is achieved, lengthen gull
wing link 1/2 turn to complete
adjustment.
NOTE: If the above procedure cannot
achieve a satisfactory wing adjustment,
check for lost motion from worn or
damaged linkage pins and/or bushings.
Also check for deteriorated yaw control
bushings. Repair as necessary and
repeat adjustment procedure.
Adjust Here
Fig. 1
Use the following procedure to align main
wings with center section.
1. Hitch sprayer to tractor and fully
extend boom.
2. Front-to-Rear angle of each main wing
section is adjusted by loosening one of
two nuts indicated in Fig. 1, followed by
fully tightening opposite nut.
Inner Wing Adjustments
(110’/120’/132’ booms Only)