46
14.
Charging
Connect the BC-3-G charger to the CEM3-G-WF DC jack. Make sure BC-3-G charge is connected to
the power source. Green light on BC-3-G turns on when charging is complete (it takes about 3.5
hours from the empty condition).
If plug in the DC jack when CEM3-G-WF is connecting on wireless LAN the tool is turned off forcibly
also wireless LAN connection does off too. In this case, tool requires longer time to re-connect on
wireless LAN then above.
The wireless LAN connection has to disconnect after close the socket communication. Press and
hold
for 2 seconds to turn off wireless LAN connection then plug in the DC jack for the charging.
i.
Check the voltage on the charger and use the appropriate power source
ii.
Stop charging as soon as the green light on the charger turns on. Excessive charging may
shorten the battery life.
iii.
The product can’t operate when it is connected to the charger.
iv.
If green light on the charger turns on and the red light stars to blink, it indicates an error. Stop
using it immediately, and contact Tohnichi or nearest Tohnichi distributor.
v.
Temperature must be kept within 0-40 degrees Celsius range when charging.
vi.
If it should emit some abnormal smell or generates abnormal heat, stop using it immediately
and move it to a safe place. Contact Tohnichi or nearest Tohnichi distributor.
vii.
When not in use for a long time, charge it to full, and remove the battery to keep it. It is
recommended that it should be charged at least once every half a year.
15.
Options
Battery pack:
BP-5
Charger (100-240V):
BC-3-G
Interchangeable head:
SH, RH, QH, RQH, DH, HH, FH
NOTE: PH of interchangeable head can’t be used.
Communication cable
CEM3-PC (D-SUB 9 pin female):
Catalog No. 575
CEM3-PC (USB A type):
Catalog No. 584
