FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 7 of 19
25/01/2021
14.
Remove (& discard) the front intrusion beam
by:
14.1.
removing (& retaining) the front
intrusion beam fasteners (4) from the
indicated locations.
14.2.
removing (& discarding) the indicated
clips (2) on the lower plastic air guides.
15.
Remove (& discard) the outer bumper support
brackets, retaining the fasteners.
16.
Remove (& discard) the inner bumper support
brackets & fasteners.
17.
Remove the indicator & park light lamps from
the
vehicle’s
light housings.
18.
Connect the supplied wiring harness inline to
both lamps, then replace the lamps back to
their original locations.
19.
Feed the wiring harness through below the
headlights.
20.
Check the operation of the indicator/park
lights, then un-plug them.
21.
Repeat the previous two steps for the opposite
side of the vehicle.
LHS SHOWN
STEP 14.2
STEP 14.1
RHS SHOWN
STEP 15
STEP 16