FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 16 of 19
25/01/2021
Step 65 only applies if no winch has been
fitted. Otherwise, please proceed to step
65.
Position the fairlead opening cover as shown &
secure it in place, using M6 x 1.0 x 20mm hex
screws (2), M6 x Ø18mm flat washers (2) &
M6 spring washers (2).
66.
Insert the nylon plugs supplied, into the
square cut-outs for the indicator/park lights
(as shown).
67.
Separate the indicator / park light body from
the backing plate.
68.
Secure the backing plate to the FPS, using the
screws provided with the light assemblies
69.
Supporting the backing plate, re-fit (clip) each
indicator / park light body (ensuring that an
adequate seal is achieved).
Ensure that the park light is towards the
outside of the vehicle.
70.
Repeat the four previous steps for the
opposite side of the vehicle.
If an optional Foglight Kit has been
purchased, install it now, referring to the
instructions provided with the kit.
Otherwise, follow the below steps to install
the provided Foglight Blanking Covers.
71.
Sandwich the foglight mounting bracket
between the Folight Washer Plates.
72.
Position the Foglight Blanking Cover as shown
opposite.
FOGLIGHT
MOUNTING
BRACKET
FOGLIGHT
WASHER
PLATES
