FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 19 of 19
25/01/2021
88.
Position the centre guard as shown & secure it
in place at the front locations using M6 x 1.0 x
20mm hex bolts (2), M6 spring washers (2) &
M6 x Ø18mm flat washers (2).
89.
Re-fit the OE underbody guard as per its
original installation, having the rear of the
centre guard inside the OE underbody guard &
ensuring that the centre guard is secured in
place at the rear, with the OE fasteners from
step
90.
Tighten all of the previously installed guard
fasteners to the relevant torque settings listed
on Page 1.
91.
Using M6 x 1.0 x 20mm hex bolts (2), M6
spring washers (2) & M6 x Ø18mm flat
washers (2), secure the number-plate in place
to the front of the FPS / number-plate bracket.
92.
Ensure that all of the relevant wiring
harnesses are connected & check that the
indicators, park lights, winch, fog-lights, etc
are functioning correctly.
93.
Ensure that all of the fasteners are fully
tightened to the appropriate torque settings &
that, as a results of fitting the product, no
vehicle components are crushed or will chafe.
