FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 9 of 19
25/01/2021
30.
Position the chassis mount on the chassis rail
ends (as shown), then loosely secure it in
place through the inner & outer centre
fastening locations (where the fasteners from
step 14.1 were originally removed), using the
fasteners retained in step 14.1.
The chassis mount should fit around
the air guides.
31.
Loosely secure the chassis mount in place,
using M10 x 1.25 x 30mm hex screws (8), M10
x Ø30mm flat washers (16) & M10 nyloc nuts
(8).
32.
Ensure that the chassis mount is level &
centered to the vehicle. Then tighten the
previously installed chassis mount & chassis
brace fasteners to the relevant torque settings
listed on Page 1.
33.
Position the wing guard bracket as shown,
then secure the chassis mount to the chassis
brace at the indicated locations, using M12 x
1.25 x 30mm hex bolts (3), M12 nyloc nuts (3)
& 1/2” x Ø1
-
1/4” flat washers (6).
34.
Repeat the previous step for the opposite side
of the vehicle.
35.
Tighten the fasteners installed in the previous
two steps to the relevant torque settings listed
on Page 1.
RHS SHOWN
OUTER LOCATION
RHS SHOWN
WING GUARD
BRACKET
