FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 18 of 19
25/01/2021
78.
Using the indicated hole in the chassis mount
as a template, drill a Ø10mm hole through
both vertical mounts in the FPS.
79.
Debur the hole & clean the areas/surfaces of
any swarf/debris, then treat the raw exposed
surfaces with a rust preventative.
80.
With the bolt heads on the inside of the
chassis mount, secure through the holes
drilled in step 78, using M10 x 1.25 x 35mm
hex bolts (2), M10 x Ø30mm flat washers (4)
& M10 nyloc nuts (2).
81.
Tighten the fasteners from the previous step
to the relevant torque settings listed on Page
1.
82.
Connect the previously installed wiring
harnesses to the relevant light assemblies.
83.
Check the operation of the light assemblies &
ensure that they are functioning correctly.
84.
Position the plastic inner guard inside the
return on the wing.
85.
Position the wing guard as shown & secure it
in place using M6 x 1.0 x 20mm hex bolts (4),
M6 spring washers (4) & M6 x Ø18mm flat
washers (4).
86.
Secure the wing guard to the wing guard
bracket, using an M6 x 1.0 x 20mm hex bolt
(1), M6 spring washer (1) & M6 x Ø18mm flat
washers (2) & M6 hex nut (1).
87.
Repeat the previous two steps for the opposite
side of the vehicle.
LHS SHOWN
RHS SHOWN
RHS SHOWN
STEP 86
