Titan TTT831HDC, Инструкция по эксплуатации

Страница: 27 / 56

EN
27
TTT831HDC-Li by TITAN
Getting
started...
NOTE: In summer use SAE #30; in winter, or if the trees have
excessive sap, use SAE #10.
3. Fill suitable lubricant into the tank using an oil funnel fitted with a filter to
avoid debris entering the tank. We recommend using environmentally
friendly chain oil specially intended to be used with this product.
4. Don’t fill the oil lower than the “MIN” mark on the oil level window (23a), but
also do not overfill or and leave approximately 5 mm of space between the
top of the oil and the inside edge of the tank to allow for expansion (Fig. 14).
5. Check the oil level window (23a) prior to start-up and regularly during
operation. Refill oil when the oil level is close to the bottom of the oil level
window (23a) (Fig. 14).
6. Wipe up spilled lubricant with a soft cloth and refit the oil tank cap (23).
NOTE: Towards the end of the season, it is advisable to put only
as much lubricant in the tank as you need for each cut, so that it is
completely used up before you store the product.
NOTE: Always dispose of lubricant, used oil and objects contaminated
with them in accordance with local regulations.
NOTE: Perform the following test before operating your product.
This product is equipped with an automatic oiling system. The oiling
system automatically delivers the proper amount of oil to the bar and
chain.
Checking the lubrication requires starting the product. Before
checking, the product must be fully assembled and all instructions
must have been read.
23a
5 mm
Fig. 14
Checking
Before you start