Titan TTT831HDC, Инструкция по эксплуатации

Страница: 21 / 56

EN
21
TTT831HDC-Li by TITAN
Getting
started...
Before you start
Setup
Assembly of cutting unit
Choose and assemble the suitable cutting unit to fit the intended use. There are
two cutting units delivered for use, one is hedger trimmer cutting unit and the
other is pruner cutting unit.
1. Loosen the locking lever (10) (Fig. 2, step 1) and pull out the pole extension
(11) (Fig. 2, step 2), then fasten the locking lever (10) (Fig. 2, step 3).
2. Move the locking sleeve (12) back onto the pole extension (11) (Fig. 2, step
4).
3. Choose one suitable cutting unit, then align the pole extension (11) with the
pole support (13) and insert it. Make sure the pins (11a) snaps in the bores
(13a) for reliable connection (Fig. 2, step 5).
4. Fit the locking sleeve (12) on the thread of pole support (13) and tighten the
locking sleeve (12) clockwise to secure the connections (Fig. 2, step 6).
WARNING! The product must be fully assembled before operation!
Do not use a product that is only partly assembled or assembled
with damaged parts!
Follow the assembly instructions step-by-step and use the pictures
provided as a visual guide to easily assemble the product! Before
using the product, familiarise yourself with the operating features
read the entire instruction manual paying particular attention to the
safety rules and operating procedures.
Do not connect the product to battery pack (32) before it is
completely assembled!
Pole assembly
1. Align the slot (7b) of the rear pole (7) with the spigot inside the front pole
(9) and insert it (Fig. 1, step 1). Make sure that the electrical cord (8a) is not
squeezed.
2. Fit the inter-locking sleeve (8) on the thread of front pole (9) and tighten the
inter-locking sleeve (8) clockwise to secure the connections (Fig. 1, step 2).
9 8a 8
7b 7
1.
2.
Fig. 1