THSEU101 User Manual
Rev. 1.00
www.thinesolutions.com |© THine Solutions, Inc. All rights reserved | Page 21 / 36
Switches and LEDs
Image Output Board contains two 8bit DIP switches (P9 and P15), CX3 reset button, and 2-wire master select switch.
DIP switch P9
Pin Name
SW#
Description
Default
MIPI_MUX_THCV_SEL
1
MIPI de-multiplexer. Controls MIPI path from THCV-242-Q-B.
SW = 0 (Off) = MIPI is routed to MIPI multiplexer
SW = 1 (On) = MIPI is routed to AP host
SW = 0
(Off)
MIPI_MUX_THCV_OE_N 2
MIPI de-multiplexer output enable. Active low.
SW = 0 (Off) = MIPI de-multiplexer is enabled
SW = 1 (On) = MIPI de-multiplexer is disabled
SW = 0
(Off)
MIPI_MUX_CX3_SEL
3
CX-3 MIPI multiplexer. Controls which MIPI stream is routed to the CX-3.
SW = 0 (Off) = Camera connector MIPI is routed to the CX-3
SW = 1 (On) = THCV-242 MIPI is routed to the CX-3
SW = 1
(On)
MIPI_MUX_CX3_OE_N
4
MIPI multiplexer output enable. Active low.
SW = 0 (Off) = MIPI multiplexer is enabled
SW = 1 (On) = MIPI multiplexer is disabled
SW = 0
(Off)
CX3_PMODE_2
5
Controls CX-3 boot options. Refer to schematic and/or CX-3
documentation for details.
SW = 0 (Off) = PMODE_2 pin is floating
SW = 1 (On) = PMODE_2 pin is low
SW = 0
(Off)
CX3_PMODE_1
6
Controls CX-3 boot options. Refer to schematic and/or CX-3
documentation for details.
SW = 0 (Off) = PMODE_2 pin is floating
SW = 1 (On) = PMODE_2 pin is high
SW = 0
(Off)
CX3_PMODE_0
7
Controls CX-3 boot options. Refer to schematic and/or CX-3
documentation for details.
SW = 0 (Off) = PMODE_2 pin is floating
SW = 1 (On) = PMODE_2 pin is high
SW = 0
(Off)
Not used
8
Not used
SW = 0
(Off)
