TC 816 Operation Manual
THERMON…The Heat Tracing Specialists
®
Operation Manual 0503 E TC 816
Page 25 of 42
8.
Change the set point to the required value by using the
or
buttons below
SETPOINT
.
9.
Confirm and store the set point with the
ENTER
button
.
10.
After configuring the relevant parameters exit the parameter configuration display by holding down
the
ENTER
button
while pressing the
button below
CIRCUIT
for about 5 seconds.
NOTE
: Parameter numbers from P16 through P29 can only be viewed with the TCD 01 tracing control dis-
play. Those parameters can only be changed with the Paracon or Visual Fecon software through a PC
connected to one of the data communication busses.
