ThermoFisher Scientific HERASAFE 2030i Series, Руководство по эксплуатации

Страница: 71 / 173

Herasafe 2030i / Maxisafe 2030i
50155215 | 61
Operation |
Chapter 6
When the “Light Bulb” button is tapped, a pop-up window appears, stating “The LED
light cannot be switched during the UV disinfection cycle. Would you like to abort the UV
cycle and switch the LED lights on?”
Figure 48 UV Cycle Alert when “Light Bulb” Button is tapped during UV Disinfection
You may then choose to continue by tapping “No”, or abort UV disinfection by tapping “Yes”.
Starting the UV Disinfection Cycle
Proceed as follows to start the UV disinfection cycle:
1. Tap the “Close window” button on the Control panel to close the window. Hold
the button all the way until the window is closed.
The tooltip-style bubble shown in Figure 49 appears above the button as a reminder
that you need to close window completely.
Figure 49 Tooltip Bubble over “Close window” Button
2. If the “UV” button is pressed while the front window is open and/or the sample
chamber illumination is on, the following pop-up window will appear.
Figure 50 UV Cycle Alert when Window is open / Illumination is on
The LED light cannot be switched during
the UV disinfection cycle. Would you like
to abort the UV cycle and switch the
LED lights on?
UV cycle
Yes No
To start the UV cycle, switch off the LED
light, close the window, and then tap on
the UV button once again.
UV cycle
OK