Thermo Scientific Surveyor UV Plus, Руководство по оборудованию

Страница: 43 / 76

3
Maintenance
Maintenance Tools
Thermo Scientific Surveyor UV/Vis Plus Detector Hardware Manual 27
Maintenance Tools
Maintaining the UV/Vis detector requires these tools:
• narrow-tip, flat-bladed screwdriver (2 mm wide)
• #2 Phillips screwdriver
• 1/4 in. open-end wrench
• 1/8 in. hex wrench (supplied)
• 3/32 in. hex wrench (supplied)
• 9/64 in. hex wrench (supplied)
Cleaning Detector External Surfaces
Keep the external surfaces of the detector clean and dry. To clean the outside of the detector,
wipe it with a dust-free cloth or a damp cloth (moistened with water only) to remove dirt or
stains.
LightPipe Flow Cell
To remove or install the LightPipe flow cell, follow these procedures:
• Removing the LightPipe Flow Cell
• Storing the LightPipe Flow Cell
• Installing the LightPipe Mounting Assembly
• Installing the LightPipe Flow Cell
CAUTION Do not disassemble the LightPipe housing or tighten the screws on the
housing. Doing so will damage the LightPipe flow cell. Thermo Fisher Scientific cannot
be held responsible for any damage done to the LightPipe flow cell by attempts to
disassemble the housing or to tighten the screws. Contact your Thermo Fisher Scientific
Service Representative with any questions regarding LightPipe flow cell maintenance or
service.