Thermo Scientific Mercury Freedom 80i, Руководство пользователя

Страница: 32 / 104

System Installation, Set Up and Shut Down
Plumbing and Electrical Hookup
2-2 Mercury System Manual Thermo Fisher Scientific
Refer to the “System Reference Drawings” in Appendix B for the system
plumbing and electrical hookup connections.
Equipment Damage
To prevent damaging the probe transducer, read the
cable labels carefully and DO NOT connect the C or D cable to the wrong
connector on the 82
i rear panel.
▲
Refer to
Table 2–1
for setting the default temperatures (or per site
requirements). At the 80 i Main Menu, select > Service > Set
Temperatures :
Table 2–1. Default Temperatures
Parameter Default Temperature
Setting
Bench Temp 45 °C
Probe Temp 220 °C
Umbilical Temp 120 °C
Converter Temp 760 °C
Failsafe Valve Temp 200 °C
Oxidizer Temp 400 °C
Use the following procedure to power up the Mercury CEMS.
Note
If the 81 i is in Service Mode, it will ignore 80 i commands.
▲
1. Apply Power to the CEMS, turn power switches ON in the following
order:
Model 82 i
Model 81 i
2. After the Model 81 i initializes and the Run screen is displayed, power
the Model 80 i .
3. To test communication from the 80 i to the 81 i :
a. Using the Model 80 i , change the Gas Mode to one of the
following: Instrument Zero, Instrument Cal, System Zero, or
System Cal.
Plumbing and
Electrical Hookup
Set Temperature
Defaults
Mercury CEMS
Power-Up Sequence