Doc. 065214-02 1/12
7
To connect the Dionex ICS-900 to an external
hub:
The Dionex ICS-900 Ship Kit includes one USB
cable
(P/N 960777). An external hub and a second USB
cable are required for this configuration.
to connect the Dionex ICS-900,
the PC, and any additional devices (for example,
an AS) to the external USB hub.
Connect the Power Cord
1. Verify that the main power switch on the rear
panel of the Dionex ICS-900 is turned off.
(The main power switch may be turned on
accidentally when the module is unpacked.)
2. Connect the power cord (IEC 320 C13) from
the main power receptacle on the rear panel
(see
) to a grounded power source.
Figure 15. Example connections:
Multiple devices connected to an external hub
The USB standard limits the USB
cable length to 5 m (5.5 yds). Each
USB device can be separated from
the PC by no more than five hubs.
Thus, each USB device can be
located no more than 30 m (32 yds)
from the PC.
Carefully secure all USB cables, the
external hub, and the hub power
cable so that they cannot be
accidentally disconnected.
B
B
B
B
A
A
A
A
USB Cables
USB
Device
(Ex: AS
Autosampler)
USB
Device
ICS-900
USB 2.0 Hub
A
PC
SHOCK HAZARD—To avoid electrical
shock, use a grounded receptacle. Do
not operate the Dionex ICS-900 or
connect it to AC power mains without
an earthed ground connection.
The power supply cord is used as the
main disconnect device. Make sure the
socket-outlet is located near the
Dionex ICS-900 and is easily
accessible.
Operation at AC input levels outside of
the specified operating voltage range
may damage the Dionex ICS-900.
DANGER D'ÉLECTROCUTION—Pour
éviter toute électrocution, il faut utiliser
une prise de courant avec prise de
terre. Ne l'utilisez pas et ne le branchez
pas au secteur C.A. sans utiliser de
branchement mis à la terre.
Le cordon d'alimentation principal est
utilisé comme dispositif principal de
débranchement. Veillez à ce que la
prise de base soit située/installée près
du module et facilement accessible.
STROMSCHLAGGEFAHR—Zur
Vermeidung von elektrischen Schlägen
ist eine geerdete Steckdose zu
verwenden. Das Gerät darf nicht ohne
Erdung betrieben bzw. an
Wechselstrom angeschlossen werden.
Das Netzkabel ist das wichtigste Mittel
zur Stromunterbrechung. Stellen Sie
sicher, daß sich die Steckdose nahe
am Gerät befindet und leicht
zugänglich ist.