Thermo Scientific Agilent 1200 Series, Руководство по подключению

Страница: 14 / 58

1
Checking the Agilent Firmware Versions
Checking the Firmware Versions from the Xcalibur Data System
2 Agilent 1200 Series Getting Connected Guide for LC Devices Thermo Scientific
Figure 2. Welcome screen on the Agilent Instant Pilot
3. Compare the firmware versions to those in Table 1 on page ix .
Checking the Firmware Versions from the Xcalibur Data System
Before you can check the firmware versions of the Agilent LC modules from the Xcalibur data
system, you must first establish communication between the modules and the Xcalibur data
system.
You can monitor the status of the Agilent modules from the Xcalibur Information view. To
open or close the Information view, choose
View > Info View .
 To check the firmware versions of the LC modules from the Xcalibur data system
1. Establish communication with the Agilent LC system as follows:
a. Connect the Agilent local area network (LAN) interface to the data system computer.
See “Connecting the Ethernet Cables” on page 34 .
b. Configure the Agilent LAN interface to use a stored IP address. See Chapter 2,
“Setting Up the LAN Interface.”
c. Specify the instrument configuration options for the LC modules in the Xcalibur
Instrument Configuration window. See
“Configuring the Agilent LC System’s
Modules” on page 20 .
IMPORTANT When you are done, to prevent data system failure, disconnect the Instant
Pilot cable from the LC stack.
Esc
Sequence
Status
Logbook
More
10:00
Select a button to continue
Display
Control
Details
Welcome
Quat Pump
Autosampler
Col Comp
Method
Agilent Technologies
7 8 9
4 5 6
1 2 3
0 . ~
i
Start Stop
Details button