Thermo King KD-II SR, Руководство пользователя

Страница: 118 / 182

Refrigeration Maintenance (Rev. 04/03)
104
3. Prepare to perform service on the low side by equaliz-
ing the high side and low side pressures through the
gauge manifold. Equalize low side pressure to 1 to
2 psig (7 to 14 kPa).
NOTE: Repeat the pump down procedure if the pres-
sures equalize above 20 psig (138 kPa). If acceptably
low pressures cannot be achieved after the third pump
down, the refrigerant must be recovered to perform
service in the low side.
4. If the reading on the gauge manifold’s high pressure
gauge increases after the high and low side pressures
have been equalized, the condenser inlet check valve
(or hot gas solenoid) is leaking.
THREE-WAY VALVE CONDENSER
PRESSURE BYPASS CHECK VALVE
The condenser pressure bypass check valve is built into the
three-way valve. This check valve controls the bypass flow
of refrigerant gas between the condenser inlet line and com-
pressor discharge line.
The check valve is closed when the unit is running on cool,
or whenever the discharge pressure is higher than the con-
denser pressure.
When the unit is running on defrost or heat, if the condenser
pressure is higher than the discharge pressure, the check
valve opens and the condenser pressure is bled off until it
drops to the level of the discharge pressure. The purpose of
the valve is to improve heating/defrosting ability and three-
way valve response.
To check the operation of the valve:
1. Remove the condenser pressure bypass check valve cap
from the three-way valve.
2. Using a screwdriver, gently turn the check valve stem
in until the valve is front seated.
3. Install a service gauge manifold set on compressor.
4. Close (front seat) the receiver tank outlet valve.
5. Operate the unit on cooling, and pump down the low
side to 20 in. (-68 kPa) of vacuum.
6. Stop the unit. The condenser and suction pressures
should remain stable, indicating no leaks.
7. Shift the three-way valve to heat position. Low side
gauge will raise slightly. High side gauge will drop to
approximately zero. Gauges will equalize.
8. Gauges will remain in this position (approximately
zero) if the three-way valve seals properly toward the
condenser and the condenser pressure bypass check
valve seals properly.
9. Back seat condenser pressure bypass check valve stem
against snap ring. Both gauges should rise indicating
the condenser pressure bypass check valve is properly
releasing condenser pressure into the discharge tube
and evaporator.
10. Replace the cap on the condenser pressure bypass
check valve.
NOTE: Valve stem MUST be back seated during nor-
mal unit operation.
11. Open the receiver tank return outlet valve, remove the
gauges and return the unit to normal operation.