Thermo King KD-II SR, Руководство пользователя

Страница: 150 / 182

Structural Maintenance (Rev. 04/03)
136
Reassembly
1. Coat the edges of the oil seals with a gasket sealant.
2. Using a suitable tool, install the seals in the end caps.
Fill the space between the seal lips with grease. Install
the assembled end cap (seal and bearing race installed)
on the oil level plug end of jackshaft housing.
3. Place the oil sling retainer on the shaft. If the bearings
were removed from the shaft, place the oil sling
retainer on the shaft while installing the bearings. If the
bearings were not removed from the shaft, press the oil
sling retainer onto the shaft through the opening in the
top of the oil sling retainer.
1. End Cap
2. Oil Sling Retainer
3. Tie Band
4. Air Vent (P/N 55-6417)
5. Shaft
Installing Oil Sling Retainer
4. Use a tie band or a hose clamp as tool to compress the
oil sling retainer enough to fit inside the jackshaft
housing.
5. Install the shaft into the jackshaft housing with oil sling
retainer on the shaft with bearing. Align the opening in
the oil sling retainer with the air vent opening in the top
of the jackshaft housing.
6. Use a punch and hammer to tap the oil sling retainer
into the jackshaft housing until it is centered beneath
the air vent opening and past the housing lip that holds
the outer race.
7. Remove the tie band or hose clamp.