Thermo King KD-II SR, Руководство пользователя

Страница: 153 / 182

Structural Maintenance (Rev. 04/03)
139
8. With the roll pin removed, place a pipe over the shaft
and drive one bearing down until the opposite bearing
and bearing spacer release from the shaft.
9. After removing one bearing and the bearing spacer,
turn the shaft upside down and drive the other bearing
off, using the pipe.
10. The bearing races can now be driven out with a punch
and replaced in the same manner.
Reassembly
1. Install the new bearings on the shaft with a 1.0 in. I.D.
pipe in the same way they were removed. The pipe
should contact the inner race, otherwise the bearing will
be damaged.
Installing Bearings
2. When replacing the bearing race on the evaporator end
of the assembly, the splash guard will come out with the
race. Press in the bearing race with a 1.9 in. O.D. pipe.
Reinstall the splash guard after replacing the bearing
race.
Installing Splash Guard
3. Install a new oil seal after replacing the bearing race
and splash guard.
Installing Oil Seal