TLC-
2000
THERAPEUTIC MEDICAL LASER
Document: 600-0013
2
3
7.
Press the Finish Treatment button on the Computer Tablet to exit the treatment.
8.
The Laser Probe can be turned off with the slide switch on the side of the Laser Probe.
Steps for Basic Treatment
To operate the Basic TLC-2000, the steps are:
1.
From the Theralase™ TLC-2000 Clinic Desktop, tap the Basic Treatment tab.
2.
Select the diagnosis that is to be treated, followed by the protocol to be used: Standard, Sport and High BMI, Low BMI
and Geriatric, or Dark Skin, and press the Save button. The Treatment Control Panel will pop up.
3.
Place the probe on the patient treatment area.
4.
Select the Treatment Mode button for one of the available Laser Probes. This communicates the time and power
settings to the Laser Probe.
5.
Start the treatment either by pressing the Black Start pushbutton on the side of the Laser Probe or the Start button
directly on the software itself.
Stop Procedure
The Laser Probe may be turned off during operation by any of the following means:
1.
Slide the switch on the Laser Probe to the OFF position.
2.
Press the Stop button or the Finish Treatment button on the Computer Tablet software.
3.
Press the Red Emergency Stop Button to stop Laser Probe operation and disable the mains power to the TLC-2000
laser system. Laser operation can only be re-started by turning the E-STOP switch a quarter turn clockwise to allow it to
“pop” out.
4.
Turn the on / off power key switch to the left
¼
turn to stop laser operation and to disable the mains power to the TLC-
2000 laser system.
The Key Switch or Remote Interlock Connector may now be removed, if desired, to disable the laser system from
unauthorized operation.
Note: Even if the Key Switch is left in the system and the Remote Interlock Connector is in place, the security
password must be known to enable laser operation; thereby, providing a 3-step security protocol to
prohibit laser use by unauthorized personnel.
Содержание TLC-2000 Series
Страница 1: ......
