Themis RES - 32XR3, Руководство по установке

Страница: 61 / 142

2-15
Themis Computer
Installation and Operation
Installation Procedures
2.1.7 Power Supply
Each of the two load-sharing (N+1 redundant) power supplies can be hot-swapped
while the system is still on and operational.
2.1.7.1 Removing a Power Supply
Perform the following steps to remove a power supply:
1. Loosen the two captive Phillips screws holding the power supply locking
bracket to the chassis (see
A in Figure 2-12 on page 2-16). Store the bracket
for later use.
2. Put the right index finger on the power supply extraction handle and the right
thumb on the left side of the power supply locking lever.
3. Squeeze the locking lever toward the extraction handle and firmly pull the
power supply from the chassis (see
B , Figure 2-12 ).
Caution: When pulling the power supply from the chassis, hold it at the bot-
tom to prevent it from falling and damaging the unit.