Themis RES - 32XR3, Руководство по установке

Страница: 59 / 142

2-13
Themis Computer
Installation and Operation
Installation Procedures
2.1.5.3 Storage-Drive Installation
To install a hard-disk/solid-state drive,
1. Make sure the latch handle of the drive to be installed is in the open position.
2. Properly orient the new drive and insert it into the vacant drive slot. If the
drive cannot be inserted into the slot, rotate it 180 degrees.
3. Push the drive toward the rear (DO NOT CLOSE the latch handle while push-
ing) until the drive is flush with the front of the chassis. The handle will swing
closed when it comes into contact with the RES-21XR3 chassis.
4. When the drive is fully inserted in its slot, insert the key into the barrel lock
and turn it 45 degrees counter-clockwise. The drive is now locked.
5. If you are installing another disk drive, repeat Steps 1-4 for each additional
drive.
Figure 2-10. RES-21XR3 Storage Drive Removal
Insert key into barrel lock and turn
A
... push the latch lock,...
B
Latch
Lock
Latch Handle
... and pull drive out with the latch handle
C
45 degrees clockwise,...
Caution: When in the closed position, the latch handle secures the drive to the
chassis. If the handle is closed before the drive is fully inserted, the latch mechanism
may not fully engage to secure the drive.