Themis RES - 32XR3, Руководство по установке

Страница: 58 / 142

2-12
Themis Computer
RES-21XR3 for X8SAX Installation Manual
2.1.5.2 Storage-Drive Removal
After opening the front doors, perform the following steps to remove and install a
hard-disk/solid-state drive:
1. Make sure the necessary precautions have been observed as per the above
Note (see “Operation” on page 2-18).
2. Locate the drive to be removed.
3. Insert the barrel lock key into the hard drive you want to remove, and turn it
45 degrees clockwise (presuming the disk drive is locked; see
A in
Figure 2-10 on page 2-13).
4. Firmly push in the latch lock until the latch handle releases away from the
drive (see
B in Figure 2-10 ).
5. Grab the latch handle and pull the drive completely away from its slot (see C
in Figure 2-10 ).
Note: Since RES-21XR3 for X8SAX disk drives are “hot-swappable”, it is not
necessary to turn off system power in order to remove and replace a drive (except
the operating system drive). However, after a warning has been broadcast to all
users, the drive being replaced should be dismounted before being removed.
Consult your operating system manual for specific details.
Caution: When pulling the storage drive from the chassis, hold it at the bot-
tom to prevent it from falling and damaging the drive.