10/2021 V 1.1
VIEW 11
01/23
Posi�on the Underframe parallel to
tray edge. If using a raised shower tray,
leave a minimum 3mm gap from the
edge of the tray (5mm is
recommended).
Use tape to mark this dimension.
Repeat for the Return Underframe
Profile.
Measure the distance from the tape
edge to the �ling and take note of this
distance.
Repeat for the Return Underframe.
F =
R =
Check the dimensions are within the
allowed adjustments by referencing the
a�ached adjustment sheet.
Subtract 22mm from the Front and
Return Underframe dimension. This is
the profile width. Mark this
measurement on the Underframe.
Cut squarely using a chop saw.
Use a fine toothed file to remove any
burrs, be careful not to damage the
surface finish.
3mm minimum
Shower Tray
x - 22mm
F
R
01
02
03
04
