10/2021 V 1.1
VIEW 11
20/23
A�ach the Glass to Glass Hinges to the
door and �ghten.
Evenly �ghten the screws un�l the
gaskets are just “nipped”.
Tighten all screws to 15.6N.
DO NOT fit the Cover Plates yet.
Measure the width of the Door (glass
width). Cut the Bo�om Door Seal
accordingly.
Trim the outside edges on both ends to
allow the two ver�cal Seals to touch
the Glass.
A�ach the Seal ensuring the Seal is
correctly oriented.
Push both Ver�cal Seals down as far as
they can go.
With a straight edge, mark where the
Seals will be trimmed. Remove the
Seals and trim with a fine toothed
junior hacksaw so they are flush with
the tops of the Glass Panels.
Replace the seals.
Outside of
enclosure
47
48
49
50
