10/2021 V 1.1
VIEW 11
15/23
Ensure the Stay Bar is level and square.
Mark the loca�on on the wall and
remove the Stay Bar.
Posi�on the Stay Bar Connector central
to the marking. Mark the holes for
drilling.
Use masking tape on the �les to help.
STAY BAR CONFIGURATION B - SB2
Using a 5mm high quality drill bit for a
clean and precise hole, drill the marked
areas, fully insert the wall plugs and fix
the Connector to the wall.
Fix Glass Clamp over the Glass and
a�ach the Stay Bar to the Wall
Connector with screws provided.
Professional Tip
If drilling ceramic tiles, place
masking tape on the tiles before
marking and drill through the
tape to prevent the drill bit from
skidding.
DO NOT use Hammer Action as
this will break the tiles.
B3
B4
B5
B6
