69623A-INS-LAB-RevB14
1
69623A / 69663A: TUB-GUARD
®
BATHTUB SAFETY RAIL
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Tools required: an adjustable wrench
Info: The most current version of these instructions can be found online at
www.grahamfield.com
.
WARNING: Important! Read and understand these instructions before assembling or
using the 69623A / 69663A Tub-Guard Bathtub Safety Rail. If you do not understand any
part of these warnings, cautions or instructions, contact a healthcare professional for
direction in the use of this product. If the Bathtub Safety Rail is not properly assembled
and adjusted, personal injury and damage to the Bathtub Safety Rail could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO
NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement
parts could cause personal injury and damage to the Tub-Guard Bathtub Safety Rail.
WARNING: This product has a weight limit of 250 lb, EVENLY DISTRIBUTED.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This
product contains a chemical known to the State of California to cause cancer and
reproductive or developmental harm.
WARNING: This product is NOT recommended for use on fiberglass or plastic bathtubs.
GF Health Products, Inc. assumes no responsibility for any damage or injury caused by
improper assembly or use of this product.
INSTALLATION
WARNING: DO NOT overtighten Bathtub Safety Rail adjustment handle.
1. Locate section of bathtub wall where Bathtub Safety
Rail is to be mounted. The Bathtub Safety Rail should
be mounted ONLY on the straight — not curved —
part of bathtub wall. Ensure the tub surface where
the Bathtub Safety Rail will be installed is smooth,
clean, and dry before installing the Bathtub Safety
Rail. Remove any dust, powder, or foreign particles.
2. Fold out the adjustment handle from the recess in
Bathtub Safety Rail body.
3. Loosen the adjustment handle by turning it counter-
clockwise until clamping mechanism is wide enough
to fit over bathtub wall. Place Bathtub Safety Rail
down onto bathtub wall. Adjustment handle should
be outside the bathtub, and clamping mechanism
inside the bathtub. Ensure the Bathtub Safety Rail is
fully seated before tightening.
4. Tighten the adjustment handle by turning it clockwise until the Bathtub Safety Rail is firmly in
place on bathtub wall. DO NOT overtighten the adjustment handle.
5. Once unit is firmly in place, fold down the adjustment handle until the handle locks back into
the recess in the Bathtub Safety Rail body.
6. To test mounting before use, apply a strong push and pull motion to the Bathtub Safety Rail. If
the Bathtub Safety Rail moves, reset it and tighten it more.
WARNING: Ensure the Tub-Guard Bathtub Safety Rail is installed as described before use.
Tub-Guard Bathtub Safety Rails
A) adjustment handle
B) clamping mechanism (one side only shown)
C) safety rail body
69623A
69663A
B
A
C
B
A
C
