Textron D722B, Руководство по запасным частям и обслуживанию

Страница: 9 / 216

GB-7
RANSOMES G PLEX II Series :WD
MAINTENANCE AND PARTS MANUAL
GB
•
The rear swing out arm is to allow you
easy access to the rear cutting head. The
cutting heads
MUST BE
in the raised
position.
DO NOT
swing the arm out with
the cutting heads in the lowered position.
WARNING
•
To avoid the possibility of serious injury,
ALWAYS be properly seated in the
operator’s seat while the engine is running.
•
To avoid the possibility of serious injury,
ALWAYS switch the reel enable switch to
the off position, stop the engine, remove
the key, and set the parking brake each
time you leave the operators seat.
1. The grass catcher
MUST BE
removed
before you swing the arm out.
2. Release the draw latch (See Fig. 12).
3. Pull the handle and swing the rear arm and
cutting head out.
4. Once you are properly seated in the
operator’s seat, restart the unit and lower
the cutting heads.
5. Shut off the unit and remove the rear
cutting head for service.
6. Once you have completed your servicing,
secure the cutting head to the rear arm.
7. Once you are properly seated in the
operator’s seat, restart the unit and raise
the cutting heads.
8. Shut off the unit and swing the rear arm
back under the unit and secure the arm
with the draw latch (See Fig. 12).
WARNING
• NEVER
attempt to drive the unit while the
rear arm is not secured by the draw latch.
Driving the unit with the rear arm out, will
result in damage to the unit, or causing
serious injury or death of you the operator
or bystanders.
1
2
Figure 12
1. Draw Latch
2. Handle
ADJUSTMENTS
WARNING
• Adjustment procedures must be performed
as specified by properly trained service
personnel
ONLY
. If assistance is needed,
contact your local Ransomes/Cushman/
Ryan Dealer.
•
To avoid the possibility of serious injury,
switch the reel enable switch to the off
position, lower the heads, stop the engine,
remove the key, and set the parking brake
BEFORE
making any adjustment.
•
NEVER
rotate the cutting reel by pushing
it with your hands or fingers. Fingers can
become caught between the reel and the
frame resulting in serious injury. Use a
ratchet with a
9 /
16”
socket on the end of the
cutting head shaft to rotate the reel during
adjustment and testing (See Fig. 13).
1
Cutting Head Shown
with
Rear Rotary Brush Ac
cessory mounted
Figure 13
1. Rotate Cutting Reel with this Screw Head